HELIX H901 Assembly Manual page 7

3/ ASSEMBLY
4
5
11
6
7
8
9
1
M5
Removeable
Cover
Separate the Pedal Covers from the Pedal frames as
shown in FIG 4
STEP 4:
Holding the Pedal Frame as shown, align the bolt holes
on the pedal frame with the bolts on the yoke of the
Crank arm. There is an indentation on the Pedal Frame
and a protrusion on the yoke. These should fit together
to allow the Pedal Frame and yoke to become even and
flush with each other.
While holding in place, first install the top bolt partially
to allow the pedal frame to "hang" on that bolt. Use the
Allen Wrench provide to tighten the bolts.
Now partially install the bottom left and bottom right
bolts. Slowly tighten all the bolts until the two parts
become perfectly aligned to each other with no space
between the parts. Then Firmly tighten all three bolts.
STEP 5:
Place the Pedal Covers on the Pedal Frames and align to
allow the frame to fit inside the cavities on the bottom
of the Pedal Covers.
Install 2 Pedal Cover Bolts in each Pedal Frame and
secure firmly. There is no need to over tighten these
bolts. They should be firm but not excessively tightened.
IT IS VERY IMPORTANT THAT IN STEP
6,7 AND 8 TO FOLLOW EACH STEP VERY
CLOSELY. IF A STEP IS MISSED OR
SKIPPED, IT MAY REQUIRE DISASSEMBLY
TO REMEDY THE ERROR AND STARTING
AGAIN AT STEP 6.
ASSEMBLY OF THE CENTER UPRIGHT TUBE
STEP 6:
Holding the Center Upright Tube as shown, first slide on
the Rubber Circle for Upright. The side of the Rubber
Circle that has a minor indentation should be positions
toward the back of the Center Upright Tube.