Brother HL-Series Technical Reference Manual page 353

Revision C 16/01/96
LT - Line Type Selection
LT [, n [, p ]] [;]
n ; Line pattern number
p ; Line pattern length (percentage or millimeters of distance between P1 and P2)
• Specifies the line type and pattern length.
• When the n parameter field is omitted, a solid line is selected.
• When the p parameter field is omitted, the pattern length is 4% of the distance between P1 and P2 (default
value ).
• The value of n is a clamped integer number.
• The value of p is a clamped real number from 0.0000 to 127.9999.
• When p is omitted, the previously set line pattern length is used.
Default
1 :
2 :
3 :
4 :
5 :
6 :
PW-Pen width
PW n[;]
w ; width (unit = 1/300 inch)
• This command specifies the width of the currently selected pen.
• The value of w is an integer number from 1 to 10.
:Solid line
:For straight line, start and end points are plotted.
:For an arc, plotting takes place for every chord angle that is set.
P
Chapter 9 "HP-GL" 26