Execute Command; Enter Command - Brother HL-Series Technical Reference Manual

Revision C 16/01/96

4.3. EXECUTE command

The EXECUTE command orders the printer to execute the specified operation.
This command is supported only by HL-660 series printer.
Syntax :
@PJL ENTER operation [<CR>]<LF>
Parameters :
• • operation
SHUTDOWN :
DEMOPAGE :
RESIFONT :
PERMFONT:
PRTCONFIG:
• If the printer receives this command, it immediately executes the specified operation.
• If this command specifies the operation which is not supported, this command is ignored.
Example :
<ESC>%-12345X@PJL<CR><LF>
@PJL EXECUTE DEMOPAGE <CR><LF>
<ESC>%-12345X

4.4. ENTER command

The ENTER command specifies which emulation the printer uses to print data.
Syntax :
@PJL ENTER LANGUAGE = emulation [<CR>]<LF>
Parameters :
• • emulation
The valuables varies according to your printer model.
• The ENTER command must be placed immediately before print data.
• The specified emulation will be used immediately after the terminator <LF> of the ENTER
command.
• If the printer does not receive the ENTER command, it uses the default printer language which is
set by the control panel or the printer language which is set by SET PERSONALITY command.
• In the case that the printer emulation is selected by the ENTER command, the printer must switch
to the defined printer language.
• If this command specifies an emulation which is not supported, data after this command is ignored
until the next UEL command.
The printer goes into the sleep mode.
The printer prints the demo page.
The printer prints the list of resident fonts.
The printer prints the list of permanent download fonts.
The printer prints the list of printer settings.
Chapter 3 "PJL" - 11