Revision C 16/01/96
Select vertical tab channel
Esc/ n
This command allows you to select a set of vertical tabs (or channel) that you defined using
the Esc b command.
All subsequent vertical tab commands use the selected tab channel's settings.
n must be in the range from 0 to 7.
The default channel is channel 0. Channel 0 is the current channel when the printer is first
switched on, or after a reset with the Esc @ command.
There are no default vertical tab settings for any channel.
LPRINT CHR$(27); CHR$(47); CHR$(5); 'Select vertical tab channel 5
Vertical tab
VT
The VT control code (ASCII 11) moves the current print position one vertical tab stop down
the page. The current vertical tab channel's settings are used.
If you have not previously selected a vertical tab channel with the Esc / command, channel 0,
the default channel, is used.
If you have not set any vertical tab stops for the current channel with either the Esc B, Esc b,
or Esc e 1 commands, the print position is moved down one line using the current line space
setting.
If there are no tab stops below the current print position a line feed is performed.
If no tab stops have been set a carriage return and line feed are performed.
LPRINT CHR$(11); ' Vertical tab
(27)(47)n
<1Bh><2Fh>n
(11)
<0Bh>
Chapter 5 " EPSON FX-850 " - 20