Husqvarna AUTOMOWER Operator's Manual page 13

Working method
Automower automatically mows the lawn.
®
It continuously combines mowing and charging.
The charging station sends out a signal that Automo-
wer can sense at a distance of 20 - 23 ft. The mower
®
starts to search for the charging station when the bat-
tery charge becomes too low. Automower
mow when it is searching for the charging station.
When Automower searches for the charging station
®
it uses one or more of three different search methods:
Irregular, Follow boundary wire and Follow guide
wire. For more information about the search
methods, see 2.3 Search method on page 15 and
Follow loop in (3-2-2) on page 54.
When the battery is charged the mower reverses,
turns around and leaves the charging station in a
randomly selected direction within the exit sector
90° - 270°.
To make it easier for Automower
the garden you can manually set how the mower will
leave the charging station, see 6.5 Installation (3) on
page 51.
When Automower ® body hits an obstacle, the mower
reverses and selects a new direction.
Two sensors, at the front and back on Automower
sense when the mower approaches the boundary
wire. Automower ® overruns the wire by up to
27 centimeters (11") before it turns. The overrun
length can be set, see Drive past wire (3-4-2) on
page 57.
The STOP button on the top back edge is mainly
used to stop the mower when it' s running. When the
STOP button is pressed down it is possible to open
the solar cell panel, under which there is a control
panel. The STOP button remains depressed until the
cover is reset again. This acts as start inhibitor.
2. PRESENTATION
does not
®
to reach all parts of
®
® ,
English - 13