Chevrolet Spark Owner's Manual page 56

3–10 INSTRUMENTS AND CONTROLS
If the charging system warning lamp
comes on while you are driving:
1. Pull safely off the road.
2. Stop your vehicle.
3. Make sure the drive belt is not loose
or broken.
4. If the drive belt is in proper working or-
der but the charging system warning
lamp stays on, there may be a problem
somewhere in the charging system.
Take your vehicle to your nearest
CHEVROLET retailer for repairs as soon
as possible.
BRAKE SYSTEM WARNING LIGHT
This light should come on when the ig-
nition is ON but the engine is not run-
ning, as a check to show you it is work-
ing properly.
The lamp should go off after the engine
starts.
If the light comes on while you are
driving, pull over and stop carefully.
If the light stays on, have the vehicle
towed for service. The brake system
should be inspected right away.
Driving with the brake warning light
on can lead to an accident. Have the
brakes checked immediately if the
brake warning light stays on.
This light also comes on when you set
your parking brake while the ignition is
ON.
The light stays on until the ignition is
turned OFF or the parking brake is fully
released.
Make sure the parking brake is fully
released before driving the vehicle.
Driving with the parking brake on
can cause the brake system to
overheat and may result in premature
wear or damage to brake system
components.
Always check that the parking brake
is fully released before you begin to
S3W1081A
drive.
CAUTION
WARNING