Chevrolet Spark Owner's Manual page 107

HOW TO CHANGE A FLAT
TYRE
If a tyre goes flat, observe following safety
instruction before you change the tyre.
Tyre change safety precautions
1. Turn on the hazard flashers.
2. Pull off the road to a safe place away
from traffic.
3. Park on a firm and level surface.
4. Turn off engine and remove key.
5. Set parking brake.
6. Have all passengers get out of vehicle
and stand in a safe place.
7. Use a wedge, block of wood, or rocks
in front of and behind the tyre that is
diagonal from the tyre you plan to
change.
Failure to follow these safety precautions
can cause your vehicle to slip off the jack
possibly causing serious injury.
How to change a flat tyre
1. Remove the jack, tyre changing tools
and spare tyre from the storage in the
luggage compartment.
2. Use the flat head screwdriver to pry off
the wheel cover (if so equipped).
If your vehicle is equipped with bolt-
on type of wheel covers, loosen 4 plas-
tic caps by a hand with the aid of the
wheel wrench and remove the wheel
cover.
3. Use the wheel wrench to loosen the
wheel nuts or bolts by one turn each.
2
3
4
1
Loosen
CAUTION
Do not remove any of the nuts or bolts
until you have raised the wheel off the
ground.
4. Insert the jack handle into the jack.
5. Rotate the jack handle clockwise to
raise the lift head slightly.
6. Locate the jack according to the fig.
below. There is a notch at the front and
rear of the vehicle under the doors.
S3W1162A
EMERGENCIES 6–3
S3W1164A