Chevrolet Spark Owner's Manual page 109

12. Replace and lightly seat the wheel
nuts or bolts by turning clockwise.
13. Turn jack handle counterclockwise
and lower vehicle to the ground.
14. Tighten wheel nuts with the wrench
firmly to 100 Nm torque in a "X" pat-
tern; 1→ 2→ 3→ 4 (See fig. below)
WARNING
Make sure to use the proper nuts or
bolts tightened to the proper torque.
Using incorrect parts or improperly
tightened wheel nuts or bolts can
cause or come off the vehicle.
2
3
4
1
Tighten
CAUTION
Improperly tightened wheel nuts can
lead to brake pulsation and rotor
damage. To avoid expensive brake
repairs, evenly tighten the wheel nuts
in the proper sequence and to the
proper torque specification.
15. Install wheel cover if required.
When installing the bolt-on type of
wheel covers, do the following:
• Put a wheel cover on the tyre.
• Fasten 4 plastic caps by a hand
snug.
• Tighten them by turning 90° addi-
tionally to the maximum 5.9 lb-ft
(8 N•m) with the wheel wrench.
Have the flat tyre fixed for future use
as soon as possible.
16. Secure the jack, tools, and the flat tyre
in their proper locations.
S3W1165A
When using the jack, the vehicle could
become unstable and move, damaging
the vehicle and causing personal in-
jury.
• Use jack at correct jacking position.
• When installing the jack for lifting
• Do not go under a jacked-up vehicle.
• Do not start vehicle while jacked-up.
• Before jacking, get all passengers
• Use jack for changing wheels only.
• Do not jack vehicle on an inclined or
NOTE
• Use jacking position nearest to the
• Block wheel diagonally opposite the
EMERGENCIES 6–5
CAUTION
the vehicle, it should be perpendicu-
lar to the ground.
out of the vehicle and clear of vehicle
and other traffic.
slippery surface.
wheel requiring changing.
wheel to be changed.
(Continued)