Sound Adjustments; Attenuating The Input Signal; Adjusting The Front Speaker Output Balance - JVC RX-E100SL Instructions Manual

Sound Adjustments

You can also use the remote control for some sound adjustments.
• When using the remote control, see also "Mastering Remote Operations" on page 32.
STANDBY
POWER
D I G I T A L
S U R R O U N D

Attenuating the Input Signal

When the input level of the analog source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
• You have to make this adjustment for each analog source.
Press and hold INPUT ATT (INPUT ANALOG/DIGITAL) so
that the INPUT ATT indicator lights up on the display.
• Each time you press and hold the button, the Input Attenuator
turns on ("ATT ON") or off ("ATT NORMAL").
INPUT
ANALOG/DIGITAL
INPUT ATT
ANALOG L R
INPUT ATT
ATT ON
Adjusting the Front Speaker
Output Balance
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speaker output balance.
• You have to make this adjustment for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
ADJUST
adjustments.
CONTROL
5/∞/3/2
TV DILECT RX-E100
ANALOG PRO LOGIC
L C R
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD DVD TV
D I G I T A L
ADJUST
Remote
NOT
ATT NORMAL
Remote
NOT
Display
INPUT ATT
HOME THEATER RECEIVER
SLEEP TUNED ST AUTO MUTING
MH
Z
KH
Z INPUT SURROUND
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR CD FM AM
2
Press CONTROL ∞ (or 5) repeatedly until
"BAL (Balance)" (with the current setting)
appears on the display.
CONTROL
IC
TO
T
* "CENTER" is the initial setting. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 or 2 to adjust the front
speaker balance.
CONTROL
MUTIN
MH
Z
KH
Z
VOL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
• Pressing CONTROL 3 decreases the left channel output
(from CENTER to L–21).
• Pressing CONTROL 2 decreases the right
channel output (from CENTER to R–21).
DSP
MODE
MASTER VOLUME
VOL
*
VOL
17