Setting Auto Surround - JVC RX-E100SL Instructions Manual

Basic Settings
STANDBY
POWER
D I G I T A L
S U R R O U N D
SETTING

Setting Auto Surround

Surround mode is automatically activated when a multichannel
digital signal comes into this receiver through the digital terminal.
You can enjoy Surround mode simply by selecting the source (with
digital input selected for that source) — Auto Surround.
To activate Auto Surround, follow the procedure below.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"AUTO SR (Auto Surround)" (with the current
setting) appears on the display.
*
CONTROL
O LOGIC
P
TL AUTO
UT ATT
* "OFF" is the initial setting. If you have already changed the
setting, "ON" will be shown.
16
CONTROL
5/∞/3/2
TV DILECT
ANALOG L C R
CONTROL
LPCM
SUBWFR LFE
DOLBY D
LS S RS
DTS
SETTING ADJUST MEMORY
DVD
DVD TV
D I G I T A L
Remote
NOT
VOL
Display
RX-E100 HOME THEATER RECEIVER
PRO LOGIC SLEEP TUNED ST AUTO MUTING
DSP
MH Z
DGTL AUTO KH
Z INPUT
INPUT ATT VOL
ANALOG/DIGITAL
INPUT ATT
VCR CD FM AM
3
Press CONTROL 3 (or 2) to select "ON."
• Each time you press the button, Auto Surround turns "ON" or
"OFF."
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
ON
: • If multichannel signals come in, an appropriate
Surround mode will be turned on
• If Dolby Digital 2 channel or DTS 2 channel
signals come in, "STEREO" will be selected.
• If linear PCM signals come in, nothing will
change.
OFF : Select this to deactivate Auto Surround.
Notes:
• This function does not take effect in the following cases:
– While playing an analog source.
– While selecting "DGTL DTS" or "DGTL D.D." as the fixed digital
input mode (see page 11).
• If Surround mode is automatically activated by Auto Surround,
another DSP mode in use will be canceled temporarily. When
multichannel digital signals stop coming in, the selected surround
mode is canceled, and the previous DSP mode resumes.
• If you press SURROUND ON/OFF (SURROUND on the remote
control) or DSP MODE with Auto Surround activated, Auto
Surround will be canceled temporarily for the currently selected
source.
Auto Surround setting will be restored in the following cases.
– When you turn off and on the unit,
– When you change the source, and
– When you reset "AUTO SR" to "ON" again.
To cancel Auto Surround
Repeat step 1 and 2, then select "OFF" in step 3.
SURROUND DSP
ON/OFF MODE
MASTER VOLUME
VOL