Wheel Motor Service (Parker); Wheel Motor Service (Eaton) - Toro Reelmaster 5210 Service Manual

Wheel Motor Service (Parker)

22
23
24
25
3
1. Cap screw (7 used)
2. End cover
3. Body seal (5 used)
4. Commutator ring
5. Commutator
6. Commutator ring
7. Manifold
8. Stator
9. Vane (7 used)
NOTE: The front wheel motors on Reelmaster 5010
machines with serial number below 311000600 are
Parker Torqmotor TG Series. Wheel motors have an
TM
identification tag on them which identifies the brand.
Right and left motors are the same basic design but the
right side motors have a reverse timed manifold to allow
correct rotation direction for forward and reverse. The
left side wheel motors are identified with a yellow dot on
the motor flange.
Hydraulic System (Rev. C)
16
17
18
19
20
21
10
8
9
3
11
Figure 68
10. Rotor
11. Wear plate
12. Drive link
13. Thrust bearing
14. Coupling shaft
15. Woodruff key
16. Thrust bearing
17. Thrust washer
Page 4 - - 80
14
15
4
5
6
3
7
3
18. Inner bearing
19. Shaft seal
20. Back- -up washer
21. Back- -up ring
22. Housing
23. Outer bearing
24. Dirt and water seal
25. Lock nut
NOTE: On machines equipped with optional Cross-
Trax AWD kit, the rear wheel motors are Parker Torq-
TM
motor TL Series.
TM
NOTE: For Parker wheel motor repair procedures, see
the Parker Torqmotor
TM
TJ, TF, TG, TH and TL Series) at the end of this chapter.
12
13
1
2
3
45 to 55 ft- -lb
(61 to 75 N- -m)
Service Procedure (TC, TB, TE,
Reelmaster 5010 Series