Permanently Connecting The Control Box; Coil Cable Assembly - Minelab X-terra 305 Instruction Manual

12

permanently ConneCting the Control box

While the X-Terra control box is designed
to be easily removable for packing and
transport, Minelab have made an option
available to permanently attach the control
box to the handle.
Remove the small circular rubber insert in
the top right-hand side of the handle.
Insert the screw provided into the hole and
tighten using a Phillips screwdriver.
Store the rubber insert in a safe place in
case you wish to reuse it in the future.
Remember to remove this screw before
attempting to disconnect the control box
from the handle. Failure to do this may
result in damage occurring.
If this option is not used, then the rubber
insert may be glued in place using a
silicone sealant or other suitable adhesive.
Wind the coil cable around the lower
and middle shaft enough times to take
up the slack.
Use the velcro tabs to keep the coil cable in
place against the shaft. It is recommended
that one tab is used on the lower shaft close
to the coil and the other tab on the middle
shaft before the cable reaches across to the
control box.
Align the coil plug and connect into the
socket in the back of the control box,
lightly tightening the retaining ring to
hold it in place.
13

Coil Cable assembly