Erasing Patterns; Factory Presets - Minelab X-terra 305 Instruction Manual

62

erasing patterns

Custom patterns are saved when
the X-Terra is switched off. To
erase custom patterns and return
to preset patterns:
Turn the detector off.
While pressing and holding
Pattern
, turn the detector
back on, by pressing Power
once.
During the start up sequence,
release Pattern .
After the start up sequence, the
patterns erased message (PE)
will appear for 3 seconds to
indicate that the current patterns
have been erased and returned
to the preset patterns.
Press and hold Press
once
The settings Sensitivity, Ground
Balance, Noise Cancel, Threshold,
Volume and Tones are saved when
the X-Terra is switched off. To
return to the preset menu values:
Turn the detector off.
While pressing and holding
Menu , turn the detector back
on, by pressing Power
once.
During the start up sequence,
release Menu .
After the start up sequence, the
factory preset message (FP), will
appear for 3 seconds to indicate
that Sensitivity, Ground Balance,
Noise Cancel, Threshold, Volume
and Tones have returned to the
preset values.

faCtory presets

Press and hold Press
once
63