Armrest Assembly; Connecting The Control Box - Minelab X-terra 305 Instruction Manual

10

armrest assembly

Place the armrest onto the top of the upper
shaft, lining up the central hole in the
armrest with a hole in the aluminium shaft.
Position the armrest to suit your arm length.
(Holding the Detector, p. 16)
Insert the screw up through the stand,
upper shaft and armrest. Tighten the
screw, being careful not to overtighten and
damage the thread.
With the velcro side facing upwards, thread
the armrest strap through both slots in the
armrest. Ensure the end of the strap will be
fastened outwards from your arm.
The X-Terra is designed to be used in
both the left and right hand.
This diagram shows the velcro strap
threaded outwards for the left arm.
Connecting
With the LCD facing up, push the control
box onto the end of the handle until it fits
into place.
The control box may be easily removed for
packing and transport in a carry bag.
Disconnecting
Brace the detector firmly against yourself,
grasp the control box and pull it away from
the handle.

ConneCting the Control box

11