Boot Loader Firmware - Ricoh M199 Service Manual

Firmware Updating
11. Close the top cover.
12. Turn off the power of the machine, and then turn it back on.
13. Print a configuration or maintenance page to check the machine's firmware version.

Do not turn off the machine until the update completion message appears on the
machine's control panel. Otherwise, the controller board will be damaged.

If the update completion message does not appear, the download failed. Try again. You
can also switch from an Ethernet connection to a USB connection and see if that works. If
you still cannot download the firmware, it may be necessary to change the EGB and/or
the controller board.

If power failed during the download, try again. If you still cannot download the firmware, it
may be necessary to change the EGB and/or the controller board.

4.3.4 BOOT LOADER FIRMWARE

This is also listed on the configuration page, but this firmware is not updated in the field.
M199/M200/M203/M204 4-30 SM