Sony DSC-P31M Service Manual page 53

SETUP 2
Item Setting
LCD
BRIGHT
xNORMAL
BRIGHTNESS
LCD BACKLIGHT BRIGHT/
NORMAL
x
BEEP
SHUTTER
x ON
OFF
VIDEO OUT
x NTSC
PAL
USB CONNECT
/
PTP xNORMAL
POWER SAVE
x ON / OFF
(DSC-P71)
98
Precautions
Cleaning
Cleaning the LCD screen
Clean the screen surface with an LCD
cleaning kit (not supplied) to remove
fingerprints, dust, etc.
Cleaning the lens
Wipe the lens with a soft cloth to remove
fingerprints, dust, etc.
Cleaning the camera surface
Clean the camera surface with a soft cloth
slightly moistened with water, then wipe
the surface with a dry cloth. Do not use any
type of solvent such as thinner, alcohol or
benzine as this may damage the finish or the
casing.
Note on operating temperature
The camera is designed for use within a
temperature range of 0° – 40° (32°F and
104°F). Shooting in extremely cold or hot
locations that exceed this range is not
recommended.
Description
/ Selects the LCD brightness. This has no effect on the recorded images.
/
DARK
Selects the brightness of the LCD backlight. Selecting "BRIGHT" makes the screen bright and easy to
see when using the camera outdoors or in other bright locations, but also uses up the battery charge
faster. Displayed only when you are using your camera with the battery pack.
– Turns on the shutter sound when you release the shutter button.
– Turns on the beep/shutter sound when you press the control button/ release the shutter button.
– Turns off the beep/shutter sound.
– Sets the video output signal to NTSC mode (Japan, USA).
– Sets the video output signal to PAL mode (Europe).
Switches the USB mode (page 44).
Selects whether to use the POWER SAVE mode (page 16).
On moisture condensation
If the camera is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense inside
or outside the camera. This moisture
condensation may cause a malfunction of
the camera.
Moisture condensation occurs easily
when:
• The camera is brought from a cold
location such as a ski slope into a warmly
heated room.
• The camera is taken from an air-
conditioned room or car interior to the hot
outdoors, etc.
To prevent moisture condensation
When bringing the camera from a cold
place to a warm place, seal the camera in a
plastic bag and leave it in the new location
for about an hour. Remove the plastic bag
when the camera has adapted to the new
temperature.
If moisture condensation occurs
Turn off the camera and wait about an hour
for the moisture to evaporate. Note that if
you attempt to shoot with moisture
remaining inside the lens, you will be
unable to record clear images.
The internal rechargeable button
battery
This camera has an internal rechargeable
button battery for maintaining the date and
time and other settings regardless of
whether the power is on or off.
This rechargeable button battery is
continually charged as long as you are using
the camera. However, if you use the camera
for only short periods it discharges
gradually, and if you do not use the camera
at all for about one month it becomes
completely discharged. In this case, be sure
to charge this rechargeable button battery
before using the camera.
Note that even if this rechargeable button
battery is not charged, you can still use the
camera as long as you do not record the date
and time.
Charging the battery
Connect the camera to a wall outlet (mains)
using the AC power adapter or install a
charged battery pack, and leave the camera
for 24 hours or more with the POWER
button set to OFF.
1-47
DSC-P31/P31M
99