Atf Temperature Sensor On-Vehicle Repair - Lexus 2005 IS300 User Manual

SST
2005 LEXUS IS300 (RM1140U)
AUTOMATIC TRANSMISSION
ATF TEMPERATURE SENSOR
ON-VEHICLE REPAIR
CAUTION:
When working with FIPG material, you must observe the
following items.
F
F
F
F
F
1.
2.
3.
4.
5.
NOTICE:
Some fluid will remain in the oil pan.
(a)
D00910
(b)
NOTICE:
When removing the oil pan, be careful not to damage the oil
pan flange.
Q07487
- ATF TEMPERATURE SENSOR
Using a razor blade and gasket scraper, remove all
the old FIPG material from the gasket surfaces.
Thoroughly clean all components to remove all the
loose material.
Clean both sealing surfaces with a non-residue sol-
vent.
Apply FIPG in an approx. 1 mm (0.04 in.) wide bead
along the sealing surface.
Parts must be assembled within 10 minutes of ap-
plication. Otherwise, the FIPG material must be re-
moved and reapplied.
REMOVE NO. 1 AND NO. 2 ENGINE UNDER COVERS
REMOVE LH FRONT FLOOR CENTER COVER
REMOVE NO. 1 REAR FLOOR BOARD
REMOVE DRAIN PLUG WITH GASKET AND DRAIN
ATF
REMOVE OIL PAN
Remove the 19 bolts.
Install the blade of SST between the transmission case
and oil pan, cut off applied sealer, and remove the oil pan.
SST 09032-00100
Author :
AT-9
AT05Y-03
Date :
1631