Connecting Speakers - JVC CA-UXL36V Instructions Manual

AM antenna
ANTENNA
1
AM EXT
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
• If cords are covered with insulation, twist
the core of the cord at the end of each cord,
then remove the insulation.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
AM LOOP
FM 75
COAXIAL

Connecting Speakers

1
For UX-L46V
SPEAKERS
Speaker cord
INPUT
For UX-L36V
Right speaker
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord to the
terminal.
Match the polarity between the unit and the speaker
terminals: (+) to (+) and (–) to (–).
• If cords are covered with insulation, twist
the core of the cord at the end of each cord,
then remove the insulation.
3
Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
– 7 –
2
3
RIGHT LEFT
Speaker cord
SPEAKER
IMPEDANCE
MIN 6
INPUT
Left speaker