Listening To Fm And Am Broadcasts; Tuning In To A Station; Presetting Stations - JVC CA-UXL36V Instructions Manual

Listening to FM and AM Broadcasts

Tuning in to a Station

1
Press FM/AM to select the band.
The unit automatically turns on and tunes in to
the previously received station (either FM or
AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold PREV ¢ or
4 NEXT for more than 1
second.
The unit starts searching for
stations and stops when a
station of sufficient signal
strength is tuned in.
If a program is broadcast in
stereo, the ST (stereo) indicator lights up.
To stop searching, press ¢ NEXT or PREV 4.
When you press NEXT ¢ or PREV 4 briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE so that the MONO
indicator lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In this stereo mode, you can
hear stereo sounds when a program is broadcasted.

Presetting Stations

You can preset 30 FM and 15 AM stations—using either
automatic presetting or manual presetting.
FM/AM
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction.
You can preset the stations you want into memory by
FM/AM
following the presetting method.
To preset stations automatically—Automatic Presetting
You need to preset stations separately for the FM and AM
bands.
PREV NEXT
On the remote control ONLY:
1
DOWN UP
PREV NEXT
2
3
• When you cannot automatically store stations you want
FM MODE
• When you unplug the AC power cord or if a power failure
MONO
– 12 –
Press FM/AM to select the band you
want to preset.
Press and hold AUTO PRESET for
more than 2 seconds.
Local stations with strong signals are searched
and stored in memory automatically.
When automatic presetting is over, the station
stored in preset number 1 is received.
Repeat steps 1 and 2 to store stations for the
other band.
Stations with weak signals cannot be detected with this automatic
presetting. To store such a station, use the manual presetting.
occurs
Preset stations with the automatic presetting are erased at once. If
this happens, preset the stations again.
Continued
FM/AM
AUTO
PRESET