Connecting The Am (Mw/Lw) Antenna; Connecting The Speakers - JVC CA-MXK10R Instructions Manual

Getting Started

Connecting the AM (MW/LW) Antenna

• Even when connecting an outside AM (MW/LW) antenna, keep the indoor AM (MW/LW) loop connected.
CAUTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System.
Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.
3. Close each of the terminals to securely connect the cords.
Right side (rear view)
CAUTIONS:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
5
AM (MW/LW) loop antenna (Supplied)
AM (MW/LW) antenna wire (not supplied)
If reception is poor, connect the outside antenna.
Red Black
Black
Red
Turn the loop until you
have the best reception.
Attach the AM (MW/LW)
loop to its base by snap-
ping the tabs on the loop
into the slot in the base.
Left side (rear view)