Listening To The Radio - JVC CA-UXG200 Instructions Manual

Listening to the Radio

To select the band (FM or AM)
From the remote control:
FM/AM/
AUDIO IN
FM
A_IN
(AUDIO IN)
On the main unit:
FM
To tune in to a station
While FM or AM is selected...
1
sec.
TUNING/GROUP
Station searching starts and the frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the searching will stop.
To stop searching manually, press either button.
• When you press the button repeatedly, the frequency
changes step by step.
If the received FM station is hard to listen
From the remote control:
FM/AM/
AUDIO IN
FM
A_IN
(AUDIO IN)
On the main unit:
FM
Reception will improve though stereo effect is lost.
The MONO indicator lights up.
To restore the stereo effect, press the button repeatedly to
select FM.
FM MONO
AM
FM MONO
AM
FM MONO
AM
FM MONO
AM
To preset the stations
You can preset 20 FM and 10 AM stations.
1
Tune in to a station you want to preset.
2
Activate the preset number entry mode.
DISPLAY/
PROGRAM
• Finish the following process while the indication on the
display is flashing.
3
Select a preset number for the station.
To select a number, see "How to
1 3
2
select numbers" on page 7.
• You can also use
4 5 6
7 8 9
0
10
4
Store the station.
DISPLAY/
PROGRAM
To tune in to a preset station
1
Select a band (FM or AM).
From the remote control:
FM/AM/
AUDIO IN
FM
A_IN
(AUDIO IN)
On the main unit:
FM
2
Select a number of the preset station.
To select a number, see "How to
1 3
2
select numbers" on page 7.
• You can also use
4 5 6
The PROG. indicator lights up on
7 8 9
the display.
0
10
kHz
MHz
or .
4 x
kHz
MHz
FM MONO
AM
FM MONO
AM
or .
4 x
8