Listening To The Radio; Basic Tuner Operations - JVC SP-UXDAB11 Instructions Manual

Listening to the Radio

Basic Tuner Operations

To
Select a band
Change the FM reception
mode (When a stereo
broadcast is hard to receive
or noisy)
For FM/AM
Select a frequency
Tune in to a preset station
For DAB
Select an ensemble
Select a service (either
primary or secondary)
Tune in to a preset service
On the System
When you change the source to DAB for the first time after plugging in the power
cord, the System automatically scans the DAB bands for available ensembles. (See
page 13.)
• For general information about DAB, see "What is the DAB system?" on page 13.
—
or
—
—
or
—
Press
On the remote
The selected band and frequency appear
on the main display.
• When an FM stereo broadcast or a DAB
service with sufficient signal strength is
tuned in, the ST (stereo) indicator lights
up on the display.
Press to improve reception.
The MONO indicator lights up on the
display. Reception will improve though
the stereo effect is lost.
To restore the stereo effect, press again.
Press and hold for more than 2 seconds.
The System starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
or
• Press during search to stop.
• Press repeatedly to change the
frequency step by step.
Press to select the preset number of the
preset station.
or
• For presetting stations, see page 11.
Press briefly while "ENSEMBLE" is displayed.
or
• You can select from the ensembles
found in the ensemble scanning.
Press briefly to change services.
• When you reach the last/first service of
an ensemble and press ¢/4, you
or
skip to the next/previous ensemble
respectively. It may take some time to
change ensembles.
Press briefly to select the preset number of
the preset service.
or
• For presetting services, see page 11.
10