Brinkmann 810-3245-0 Owner's Manual page 8

INS_810-3245-S_BI.qxd
Step 11
Attach one handle stand using two
M6 x 12mm Phillips head bolts and two
M6 x 5mm hexagonal nuts. Next insert
hood handle into handle stand. Place the
other handle stand over handle and attach
by using two M6 x 12mm Phillips head
bolts and two M6 x 5mm hexagonal nuts.
Step 12
Attach one half of each hinge to the
outside back of the body using
M6 x 28mm Phillips head bolts. Thread
bolts into nuts welded to the inside of the
grill body but do not tighten. Attach the
other half of each hinge to the outside
back of the lid using M6 x 28mm Phillips
head bolts. Thread bolts into nuts welded
to the inside of the lid but do not tighten.
Step 13
Rest lid on the grill body and align hinges
to insert hood pivot pins. Insert hitch pins
into hood pivot pins. Tighten all hinge
screws on lid and grill body until secure.
Step 14
Insert adjuster cranks through front of
grill body and into crank brackets. Rotate
clockwise until cranks engage charcoal
grates.
7
9/26/05 12:35 PM Page 8
Handle
Hitch Pin
Hood Pivot Pin
Handle
Stands