Declaration Of Conformity - York RVHC 09-12DS Installation & Owner's Manual

Minisplit high wall air conditioner

Hide thumbs

Table Of Contents

Table of Contents

DECLARATION OF CONFORMITY

Type of Equipment

Brand Name

Type Designation

Application of Council

Directive (s)

The following harmonized standards have been applied:

Standard (s)

EN 60335-2-40/A1:2000

EN 55014-1:2000/A2:2002

EN 55014-2:1997/A1:2001

EN 55022:1998/A1:2000

EN 61000-3-2:2000

EN 61000-3-3:1995/A1:2001

EN 61000-3-11:2000

EN 60825

EN 60335-1:1994+A11:1995+A1, A12:1996+A13, A14:1998+A15, A2:2000+A16:2001

EN 60335-2-40:1997+A1:2000

EN 55014-1:1993+A1:1997/A2:1999

EN 55104-2:1997

EN 61000-3-2:1995/A1:1998/A2:1998

EN 61000-3-2:1995/A14:2000

EN 61000-3-3:1995

EN 60335-2-40:2003

EN 50366:2003

EN 60335-1:2002 +A11

EN 55014-1/A2:2002

EN 55104-2/A1:2201

The product complies with the harmonized European safety standards and harmonized EMC standards listed above.

We have internal production control system that ensures compliance between the manufacturer products and the technical documentation.

The product is CE mark.

We declare under our sold responsibility that the equipment follows the provisions Of the Directives stated above.

Authorized Representative:

CM Choi

Shipping Manager

YORK International (Northern Asia) Ltd.

15/F., Tower II, World Trade Square, 123 Hoi Bun Road, Kwun Tong, Kowloon, Hong Kong

Telephone: (852) 2331 9286 Fax: (852) 2331 9840

Technical Service Division: Telephone: (852) 2331 9286 Fax: (852) 2304 0068

This product contains refrigerant under pressure, rotating parts, and electrical connections which may be a danger and cause injury!

All work must only be carried out by competent persons using suitable protective clothing and safety precautions.

Read the Manual

1. Isolate all sources of electrical supply to the unit including any control system supplies switched by the unit. Ensure that all points of electrical and gas

isolation are secured in the OFF position. The supply cables and gas pipework may then be disconnected and removed. For points of connection refer

to unit installation instructions.

2. Remove all refrigerant from each system of the unit into a suitable container using a refrigerant reclaim or recovery unit. This refrigerant may then be

reused, if appropriate, or returned to the manufacturer for disposal. Under No circumstances should refrigerant be vented to atmosphere. Where

appropriate, drain the refrigerant oil from each system into a suitable container and dispose of according to local laws and regulations governing disposal

of oily wastes.

3. Packaged unit can generally be removed in one piece after disconnection as above. Any ﬁ xing down bolts should be removed and then unit lifted from

position using the points provided and equipment of adequate lifting capacity. Reference MUST be made to the unit installation instructions for unit weight

and correct methods of lifting. Note that any residual or spilt refrigerant oil should be mopped up and disposed of as described above.

4. After removal from position the unit parts may be disposed of according to local laws and regulations.

J355-EN.indd 20

DECLARATION OF CONFORMITY

Air Conditioners

YORK

HAEA-HADA07/09/12FS, HAEB-HADB07/09/12FS, HAEC-HADC07/09/12FS, HAKA-HAJA07/09/12FS,

HAKB-HAJB07/09/12FS, HAKC-HAJC07/09/12FS, HEEB-HEDB07/09/12/18/24/30FS,

HEKB-HEJB07/09/12/18/21/24/30FS, HLEA-HLDA07/09/12/18/24FS, HLCA-HLHA24/28/FS,

HMEA09MC/MD/ME, HMDA18MC, HMDA21MD, HMDA27ME, HMKB09MC/MD/ME/MF,

HMKB12MD/MF, HMJB18MC, HMJB21MD, HMJB27ME, HMJB30MF, HRKB09AB/AG/AH,

HRKB12AG, HRJB18AB, HRJB21AG, HRJB27AH, HRKA09AB, HRJA18AB,