Front Brake Pads - PIAGGIO Beverly 250 USA Workshop Manual

Braking system
Disc Inspection
Checking the disc is important; it must be perfectly
clean, with no sign of rust, oil or grease or other
dirt and must not show signs of deep scoring.
Characteristic
Thickness of a new front disc
4.0 mm
Disc thickness at wear limit (front)
3.5 mm
- Remove the wheel and check using the appro-
priate tools that the axial run-out of the brake
surface is within the prescribed limits.
- If this is not the case, replace the disc and repeat
the test.
WHEN INSTALLING, THOROUGHLY CLEAN
THE DISC AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm

Front brake pads

Removal
Proceed as follows:
- Remove the front calliper.
- Loosen the two pins shown in the figure that lock
the two pads.
- Remove the pads, being careful of the pads'
spring clamp.
- Check the thickness of the pads.
Characteristic
Minimum value
1.5 mm
See also
Front brake calliper
BRAK SYS - 8
Beverly 250 USA