PIAGGIO Beverly 250 USA Workshop Manual page 217

Beverly 250 USA
- Loosen the nut and lock nut on the left-hand side
of the scooter (see figure) and unscrew the spindle
from the opposite side.
- Remove the retaining screw of the rear brake
pipe shown in the figure.
- Loosen the nut on the inside of the frame from
the left-hand side (see figure) and remove the rel-
evant spindle;
- Remove the swinging arm.
Overhaul
- Check that the silent bloc is not damaged. If there
is, replace it.
- Remove the Seeger ring shown in the photo-
graph
- Remove the full silent bloc bracket
- Hold the full silent bloc bracket in the clamp
- Using the appropriate tool, remove the silent bloc
from the bracket from the side corresponding to
the inside of the vehicle. This is to guarantee the
tool is centred properly on the support
Specific tooling
020271Y Tool for removing-fitting silent bloc
Suspensions
SUSP - 15