Plastic Roller - PIAGGIO Beverly 250 USA Workshop Manual

Engine
Refitting
- Heat the roller and insert the bearing using the
specific punch:
Specific tools:
Specific tooling
020455Y 10-mm guide
- Refit the roller with the special screw.
- Tighten to the specified torque.
- Refit the intake throat with the O-ring, the sump
sealing gasket and a the fan housing.
Locking torques (N*m)
Anti-flapping roller 12 - 16

Plastic roller

- Check that the roller does not show signs of wear
and that it turns freely.
- Remove the special clamping screws as indica-
ted in the photograph
- Check the outer diameter of the roller does not
have defects that could jeopardise belt functioning
- For refitting, place the roller with the belt contain-
ment edge on the engine crankcase side
- Tighten the wrench to the prescribed torque.
Locking torques (N*m)
Anti-flapping roller 12 - 16
ENG - 4
Beverly 250 USA