Water Pump - Overhaul - PIAGGIO Beverly 250 USA Workshop Manual

Beverly 250 USA

Water pump - overhaul

- Remove the complete flywheel cover
- Remove the stator
- Remove the pump cover by loosening the 3 fixing
screws
- Remove the sealing gasket
The pump can be services using the special tool
and a press. The special tool is designed to be
used with the presses most commonly found in
workshops. For those presses equipped with a 35-
mm piston and protective cap with fixing screw, it
is sufficient to remove the cap and install the com-
ponents of the special tool in its place. The special
tool can be prepared in advance depending on its
use on presses equipped with piston with a threa-
ded type of coaxial coupling tang or cylindrical with
stop groove. Then prepare the threaded ring with
the adapter suitable for the coupling of the press
used.
- Position the flywheel cover in the hydraulic press
by inserting the impeller in the ring that is part of
the special tool, as shown in the photo
N.B.
POSITION THE BASE WITH THE SURFACE
PROVIDED WITH BETTER FINISH TURNED
TOWARDS THE FLYWHEEL COVER. FAILURE
TO COMPLY WITH THIS INSTRUCTION MAY
RESULT IN DETERIORATION OF THE SUR-
FACE INTENDED FOR THE COOLANT'S SEAL.
Specific tooling
020628Y Water pump service kit
Cooling system
COOL SYS - 3