PIAGGIO Beverly 250 USA Workshop Manual page 214

Suspensions
- Insert the stem into the fork clamp.
- Do up the clamp once to allow the stem closure
upper cap to be tightened.
- Check that the sealing ring on the cap is in good
working order, then tighten the cap on the stem to
the prescribed torque.
- Loosen the fork clamp screws and ensure the
stem closure cap is fitted properly on the clamp.
- Tighten the clamp screws to the prescribed tor-
que.
Specific tooling
020376Y Adaptor handle
020359Y 42x47-mm adaptor
Locking torques (N*m)
Fork clamp screws 20 ÷ 25 Stem upper cap 15
÷ 30 Lower screw with copper washer 25 - 35
Refitting
- Grease using lithium soap grease on the roller
bearings.
Recommended products
AGIP GREASE PV2 Grease for the steering
bearings, pin seats and swinging arm
White anhydrous-calcium based grease to protect
roller bearings; temperature range between -20 C
and +120 C; NLGI 2; ISO-L-XBCIB2.
- Insert the fork into the headstock.
- Insert the spacer ring.
- Using an appropriate tool do up the first ring nut
in the steering tube (upper steering ball bearing).
Tighten to the prescribed torque.
- Install the space washer.
- Using the special tool, tighten the second locking
ring nut in the steering tube to the prescribed tor-
que.
SUSP - 12
Beverly 250 USA