•
Cancellation during the transmission
If the [STOP] button is pressed during the direct transmission or memory input, the display to
confirm the cancellation appears. The communication is finished normally regardless of the
presence/absence of the next page or mode changes by pressing the [STOP] button.
If the [STOP] button is pressed anytime except during the transmission of the image data,
DCN is forcibly sent to terminate the communication.
Press the [JOB STATUS] button, and select the transmission job to cancel, then press the
[CANCEL] button on the LCD display to cancel the memory transmission or polling transmis-
sion.
Transmtter
Receiver
3
[ JOB STATUS ] button
[ CANCEL ] button
Fig. 3-3
© 2006 - 2011 TOSHIBA TEC CORPORATION All rights reserved
GD-1210/1250/1270/1160/1260
DIALING/COMMUNICATION CONTROL
3 - 7