Toshiba GD-1210 Service Manual page 37

3) Regular size reduction printing (13–517: 1)
- When the discard and vertical reduction printing cannot be applied to the received image, and
any of the combinations A3 → B4, A3 → A4, B4 → A4, B4 → B5, B4 → A5, A4 → B5, A4 → A5,
COMP → LT, COMP → ST, LD → COMP, LD → LG/LT, LD → ST, LT → ST, FOLIO → B5, FOLIO
→ A5 is satisfied, the regular size reduction printing is performed.
In case that the recording data length is within the effective printing length A, but the recording
paper of the same size as the original's or larger size is not available;
A
B
In case that the recording data length exceeds the effective printing length A, the vertical reduc-
tion printing is not applicable and larger size recording paper is not available;
(In the following example, A4/LT original was sent but the recording length exceeds A4 size and
the data do not fit in A4/LT even if the vertical reduction is performed. The reduction B4 → A4 or
A3 → A4 is applied in this case.)
A
C
B
D
© 2006 - 2011 TOSHIBA TEC CORPORATION All rights reserved
A × reduction
ratio
B × reduction
ratio
A3 B4, A3 A4
B4 A4, B4 B5, B4
A4 A5 , COMP LT, COMP
LD COMP, LD LG/LT, LD
LT ST, FOLIO B5, FOLIO
Fig. 2-2
A × reduction
B × reduction
ratio
D × reduction
ratio
Fig. 2-3
2 - 5
A5, A4 B5,
ST,
ST,
A5
ratio
C × reduction
ratio
GD-1210/1250/1270/1160/1260
LSU-RELATED FUNCTIONS
2