Toshiba GD-1210 Service Manual page 36

1) Discard printing
- Since the trailing edge area of the original is normally blank, this blank area is cut off to allow the
image fit in one sheet in this mode. Image reduction is not performed.
- Maximum discarding amount:
0 mm: Discard not performed
10 mm: Corresponding to the inside the TTI
18 mm: Corresponding to the outside the TTI 1
22 mm: Corresponding to the outside the TTI 2
34 mm: A4 → LT conversion
(TTI: Transmission Terminal Identifier)
When the discard function is ON (13–378:1):
Actual size recording is performed with no vertical reduction nor division. The original image is
recorded as it is. Namely, the data exceeding the effective printing area are discarded.
Area B is discarded.
Discard parameter (13-375: 0 to 4)
The following parameters are available:
Discard function
OFF
ON
Reference: These parameters should be set by the service technician (in the FAX Function Mode).
2) Vertical reduction printing (13–377: 0)
- The recording data length is reduced so that the image fits in the recording paper.
The data can be reduced up to 90/75%, and the machine automatically selects the appropriate
ratio.
GD-1210/1250/1270/1160/1260
LSU-RELATED FUNCTIONS
A
B
A : Effective printing length
B : Recording data length outside the
( A + B = Recording data length )
Fig. 2-1
Length of B (Discard parameter)
0 mm
10 mm
18 mm
22 mm
34 mm
A
effective printing area
© 2006 - 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 4
Set value
0
1
2
3
4