Daikin Super Multi Plus D-Series Service Manual page 165

Instruction
Outdoor Unit
19
Indoor Unit
1. Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front grille
5. Grille tab
6. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal operation
and energy saving operation.
7. Display
8. Air outlet
9. Flap (horizontal blade)
10. Louvers (vertical blades):
• The Louvers are inside of the air outlet.
11. Operation lamp (green)
12. TIMER lamp (yellow)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation.
Outdoor Unit
18. Air inlet: (Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
154
18
14. Indoor Unit ON/OFF switch:
15. Packaging materials: 50 class only
16. Room temperature sensor:
17. Signal receiver:
21. Drain hose
22. Earth terminal:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refer to the following table.
Temperature
Mode
FTKS COOL
AUTO
FTXS
• This switch is useful when the remote control is
missing.
• If any packaging materials are included, please
remove before operating.
• It senses the air temperature around the unit.
• It receives signals from the remote control.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............. beep-beep
• Settings changed........... beep
• Operation stop............... beeeeep
• It is inside of this cover.
SiEBE18-526
20
21
22
Air flow
setting rate
22°C AUTO
AUTO
25°C
System Configuration