Indoor Unit - Daikin Super Multi Plus D-Series Service Manual

SiEBE18-526
Outdoor Unit
18

Indoor Unit

1. Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of the
air filters.
3. Air inlet
4. Front grille
5. Grille tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
8. Display
9. Air outlet
10. Flaps (horizontal blades)
11. Louvres (vertical blades):
• The louvres are inside of the air outlet.
Outdoor Unit
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
Appearance of the outdoor unit may differ from some models.
System Configuration
17
22
12. Indoor UnitON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Mode
FTKS COOL
FTXS AUTO
• This switch is useful when the remote control is
missing.
13. Operation lamp (green)
14. TIMER lamp (Yellow)
15. HOME LEAVE lamp (red)
16. Signal receiver:
• It receives signals from the remote control.
• When the unit receives a signal, you will hear a
short beep.
• Operation start.............. beep-beep
• Settings changed.......... beep
• Operation stop.............. beeeeep
21. Earth terminal:
• It is inside of this cover.
22. Outside air temperature sensor:
• It senses the ambient temperature around the
unit.
Instruction
19
20
21
Temperature
Air flow
setting
rate
22°C
AUTO
AUTO
25°C
151