Figure 5-3. Main System Config Page - Garmin GNS 530W Installation Manual

CHANNEL OUTPUTS
Selection
Off
Aviation
Avtn no alt
Crossfill
GDL 69
HW EGPWS
Ryan TCAD
WX-500
[1] The MX20 will not use GPS altitude from the 400W Series unit. The GMX200 will use the GPS
altitude.
5.3.3 MAIN SYSTEM CONFIG
Select the MAIN SYSTEM CONFIG page (see Figure
5-3). This page allows you to configure the Fuel,
Terrain, and Discretes options.
Fuel
Select Fuel in the CONFIGURE field to select the
FUEL TYPE (AV Gas, Jet A, or Jet B).
Selection
AV gas
Jet A
Jet B
Page 5-6
Rev. D
Description
No unit(s) connected to output of this channel.
Serial position, altitude, velocity, and navigation data to the following
units:
Argus 3000, 5000, or 7000 Moving Map
Electronics International FP-5L Fuel Flow Computer (non-TSO'd)
Garmin MX20 (V5.6 or later), GMX 200 [1]
Garmin GPSMAP 195, GPSMAP 295 or GPS III Pilot
Garmin GPSMAP 196, GPSMAP 296, and GPSMAP 396
Garmin GTX 327 Transponder
JP Instruments EDM-700 or EDM-760 Engine Monitor
Shadin 91204XM Digital Fuel Management System
Shadin 91053XM Digital Fuel Management System
Shadin 9628XX-X Fuel/Air Data Computer
Stormscope Series II (with NAVAID) Moving Map
Serial position, velocity, and navigation data to the following units:
Garmin MX20 (V5.5 or earlier)
Horizon DDMP
INSIGHT TAS 1000 Air Data Computer
Serial transfer of flight plans and user waypoints between two 500W
Series units.
Serial communication to a Garmin GDL 69/69A.
Serial communication to a Bendix/King (Honeywell) KGP 560 EGPWS.
Serial communication with a Ryan TCAD 9900B Series system.
Serial communication to an L3 Communications WX-500 Stormscope.
Description
The aircraft is using Aviation gas (5.8 lbs./gal.)
The aircraft is using Jet A or Jet A-1 fuel (6.7 lbs./gal.)
The aircraft is using Jet B (JP-4) fuel (6.5 lbs./gal.)
Figure 5-3. MAIN SYSTEM CONFIG
Page
500W Series Installation Manual
190-00357-02