Table 3-4. Pin Contact Part Numbers - Garmin GNS 530W Installation Manual

78 pin conn
(P5001/5050)
Connector High Density Pin
Type
Wire Gauge
Garmin P/N
Military P/N
AMP
Positronic
ITT Cannon
1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
2. Alternate contacts for 18 AWG wire: As an alternative to the Positronic contacts listed (and
provided in the installation kit), the installer may use contacts made by ITT Cannon under P/N
031-1007-001. These contacts require the use of a different crimp tool positioner than shown
in the table, with the part numbers as follows: Daniels P/N K250, Astro P/N 616245, or ITT
Cannon P/N 980-0005-722.
3. For the card-edge connector pin contacts, use AMP part number 90272-1 or equivalent
crimping tool.
To prevent a possible short across the pins in the wiring harness, Teflon shrink tubing P/N 312-00005-05,
provided in Connector Kit 011-00351-00 (P5002) covers the oversized power and ground pin contacts
P/N 336-00023-00 (pins 11, 12, 21, 22) that protrude from the back of the connector shell. Before
crimping the pins onto the wire:
1. Cut the tubing (312-00005-05) into 4 equal lengths.
2. Slide a short piece of the tubing over the wire.
3. Strip the wire and crimp the pin (336-00023-00) onto the wire.
4. Insert the pin into the connector shell.
5. Slide the tubing over the exposed portion of the pin and shrink using a heat gun.
500W Series Installation Manual
190-00357-02

Table 3-4. Pin Contact Part Numbers

44 pin
conn
(P5006)
Standard Density Socket Contact
Contact
22-24 AWG
336-00021-00 336-00023-00
M39029/58-360
204370-2
M39029/58-360
030-2042-000 See Note 2
25 pin connector (P5002)
18 AWG 20-24 AWG
336-00022-00
N/A M39029/63-368
N/A 205090-1
FC6018D M39029/63-368
031-1007-042
NOTES
Shield ground
connector
.1-inch Pitch Card-Edge
20-24 AWG
336-00029-00
N/A
583853-4
N/A
N/A
Page 3-7
Rev. D