Pausing A Sonar Or Flasher Page - Garmin Fishfinder 340C Owner's Manual

TIME—the time of day, shown using your selected time format.
TIMER—an alarm that counts down or up in the increments that
you set in the Alarms System sub tab.
TURN—the degrees that you must turn left or right to make your
direction of travel match your bearing. Steer left (L) or right (R)
until this reads 0 to go directly to your destination.
VMG (velocity made good)—the rate of closure to a destination
based on your current speed and course.
VOLT—the current battery voltage input.
WTR TEMP (water temperature)—the water temperature at the
transducer.
XTE (crosstrack error)—how far off the chosen course you are,
measured by your selected distance units. This indicates if you are
to the left or right of the course.
Fishfinder 340C Owner's Manual
U F 340C >
SING THE ISHFINDER

Pausing a Sonar or Flasher Page

Use a paused screen to take a better look at sonar returns. The
depth continues to update while the page is paused, but the
Fishfinder does not show any new sonar data until the Sonar Page
resumes scrolling. You might see a discontinuity from where the
sonar information stops to where it starts again when you resume
scrolling the screen.
To pause and unpause the Sonar or Flasher Page:
From the Sonar or Flasher Page, press PAUSE to stop the
scrolling. Press PAUSE again (or QUIT) to resume scrolling.
P S F P
AUSING A ONAR OR LASHER AGE
39