Figure 5-2. Main Rs-232 Config Page - Garmin GNS 530W Installation Manual

5.3.2 MAIN RS-232 CONFIG Page
Select the MAIN RS-232 CONFIG page (see Figure 5-2).
Change the selectable RS-232 inputs and/or outputs to
match that of the equipment installed in the aircraft.
Interfacing systems listed in the following tables are provided for reference only. Refer
to Appendix G to determine if the interface to a particular system is approved under the
400W/500W Series AML STC.
CHANNEL INPUTS
Selection
Off
Arnav/ei-fuel
Crossfill
GDL 69
Icarus-alt
Ryan TCAD
Shadin-adc
Shadin-alt
Shadin-fadc
Shadin-fuel
WX-500
500W Series Installation Manual
190-00357-02
Description
No unit(s) connected to input of this channel.
Serial fuel flow information from the following units:
ARNAV FC-10, FT-10
Electronics International FP-5L
Serial transfer of flight plans and user waypoints between two 400W/500W
Series units
Serial data input for in-flight access to weather and messaging from the
following units:
Garmin GDL 69/69A
Serial altitude data from the following units:
Icarus Instruments 3000
Sandia SAE5-35
Garmin GTX 327 Transponder
Trans-Cal Industries IA-RS232-X, SSD120
ACK Technologies A-30 (Mod 8 and above)
Traffic information from a Ryan TCAD 9900B or 9900BX Series system.
Serial air data information from the following units:
Shadin ADC 200, 200+, 2000
Serial altitude data from the following units:
Shadin 8800T, 9000T, 9200T
Serial air data and fuel flow information from the following units:
Shadin 9628XX-X Fuel/Air Data Computer
INSIGHT TAS 1000 Air Data Computer
Serial fuel flow information from the following units:
Shadin 91053XM Digital Fuel Management System
Shadin 91204XM Digital Fuel Management System
JP Instruments EDM-700 or EDM-760 Engine Monitor
Lightning strike information from an L3 Communications WX-500
Stormscope.
Figure 5-2. MAIN RS-232 CONFIG
NOTE
Page
Page 5-5
Rev. D