Perkins 103-06 Workshop Manual page 14

External Oil Pipe
A. Loosen and remove two banjo bolts at cylinder
block main oil galley and cylinder head
assembly.
B. Remove clamp from fuel injection pump.
Cylinder Head Assembly
A. Loosen cylinder head bolts starting from the
centre, in a circular pattern using several
steps of equal torque. Remove head.
Tappets
A. Pull tappets from the machined bores in cylinder
block.
Fuel Lift Pump
A. Loosen two cap screws and lift from its bore;
remove joint.
PB008
Fuel Injection Pump Assembly
A. Remove two bolts and nuts securing fuel injec-
tion pump to cylinder block. Slowly lift and posi-
tion fuel injection pump until access to link snap
pin is gained.
B. Remove snap pin and remove link from control
rack. Remove fuel injection pump and shim
pack.
NOTE: Injection timing is determined by the
shim pack between fuel injection pump flange
and cylinder block mounting face. The thickness
and number of shims should be checked and
recorded to aid re-assembly.
PB009
PB010
PB011
P8012