Table of Contents
Advertisement
Optional Equipment
4 2
7
Install the rheostat onto the control cover.
a
8
Attach the wiring harness to the gas control valve, on/off switch, rheostat, and snap disc switch
following the directions below.
Snap Disc
9
Position the wiring harness under the burner and re-attach the control cover (see step # 6 above).
Make sure the wiring harness does not contact the burner or blower.
10 Turn on the appliance and check operation (the blower will not turn on until the stove is at full
temperature – 15 minutes on high).
Travis Industries
Remove the button plug
from the control cover.
Gas Control Valve
(for qualified installers only)
NOTE: this tab fits
into the hole on the
control cover.
Back of
on/off switch
1 0 0 - 0 1 1 5 5
Attach the rheostat to the control co
b
with the included nut and star washe
1/2"
Wrench
Rheostat
Wires
4 0 4 0 9 0 3
c
Attach
the kn
Hide quick links:
Advertisement
Table of Contents
