10
Leveling Bolt Installation
Two leveling bolts are included to level the insert if the fireplace has a stepped-up hearth. To install, raise
the rear of the insert up and insert the leveling bolts into the holes in the rear corners of the insert. Adjust
the bolts until they extend the same height as the hearth steps up. After the insert is installed, fine-tune
the leveling bolts to level the insert.
This distance is the
hearth step-up. The
leveling bolts should
stick out this far from the
base of the insert.
Flue Installation
The flue must be 6" (150mm) diameter stainless steel.
Use a starter section and screws to secure the flue to the insert.
© Travis Industries
Installation
Fireplace
Hearth
(for qualified installers only)
100-01280
The leveling bolts go
into the holes at the
rear corners of the
insert.
Figure 4
4141215