Startup
Quick Start
2.2.4 How to Connect the Phone
Step by Step
2.3 Quick Start
16
Write your phone number and the emergency numbers for the fire and police
departments on the included label and attach it to the telephone housing
where applicable, e.g. underneath the handset.
Related Topics
1) Plug the LAN cable into the connector
and connect the cable to the LAN resp. switch.
a) If PoE (Power over Ethernet) is to be used, the PSE (Power Sourcing
Equipment) must meet the IEEE 802.3af specification.
INFO: The required power supply for the OpenScape Desk
Phone IP 35G must comply with the Power Consumption/Supply
Class 2.
b) Only if Power over Ethernet (PoE) is NOT supported, you have to use the
optional plug-in power supply:
INFO: The order no. for the plug-in power supply is region-
specific:
- EU: C39280-Z4-C510
- UK: C39280-Z4-C512
- USA: C39280-Z4-C511
Plug the power supply unit into the mains. Connect the plug-in power
supply unit to the
2) If applicable, connect the following optional jacks:
•
LAN connection to PC
•
Headset (accessory)
Related Topics
This section describes a typical case: the setup of an OpenScape Desk Phone
endpoint in an environment using a DHCP server and the web interface. For
different scenarios, cross-references to the corresponding section of the admin-
istration chapter are given.
INFO: Alternatively, the DLS (OpenScape Deployment Service)
administration tool can be used. Its Plug & Play functionality
allows to provide the phone with configuration data by assigning
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
at the bottom side of the telephone
jack at the bottom side of the phone.
A31003-D3000-M100-01-76A9, 02-2013