Checking The Final Drive Oil Level - Yamaha FJR1300R Service Manual

ADJUSTING THE SHIFT PEDAL/CHECKING THE FINAL
DRIVE OIL LEVEL/CHANGING THE FINAL DRIVE OIL
NOTE:
Make sure that the mark on the shift pedal is
between the marks on the frame.
c. Tighten both locknuts.
L LLL L LLL L L LLL L
EAS00144

CHECKING THE FINAL DRIVE OIL LEVEL

1. Stand the motorcycle on a level surface.
NOTE:
@
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• final drive housing oil filler bolt 1
3. Check:
• final drive oil level
The final drive oil level should be to the bot-
tom brim 1 of the filler hole.
Below the bottom brim → Add the recom-
mended final drive oil to the proper level.
Recommended oil
Shaft drive gear oil
(Part No.: 9079E-SH001-00)
4. Install:
• final drive housing oil filler bolt
EAS00145
CHANGING THE FINAL DRIVE OIL
1. Place a container under the final drive
housing.
2. Remove:
• final drive housing oil filler bolt 1
• final drive housing oil drain bolt 2
Completely drain the final drive housing of
its oil.
3 - 58
CHK
ADJ
L LLL L L LLL L L LLL L LLL
·
23 Nm (2.3 m · kg, 17 ft lb)