Checking The Clutch Boss; Checking The Pressure Plate; Checking The Clutch Push Rods; Checking The Primary Driven Gear - Yamaha FJR1300R Service Manual

CLUTCH
EAS00285

CHECKING THE CLUTCH BOSS

1. Check:
• clutch boss splines
Damage/pitting/wear → Replace the clutch
boss.
NOTE:
@
Pitting on the clutch boss splines will cause
erratic clutch operation.
EAS00286

CHECKING THE PRESSURE PLATE

1. Check:
• pressure plate 1
Cracks/damage → Replace.
• bearing 2
Damage/wear → Replace.
EAS00288

CHECKING THE CLUTCH PUSH RODS

1. Check:
• O-ring 1
• short clutch push rod 2
• long clutch push rod 3
• ball 4
Cracks/damage/wear → Replace the defec-
tive part(s).
2. Measure:
• long clutch push rod bending
Out of specification → Replace the long
clutch push rod.
Long clutch push rod bending
limit
0.37 mm (0.015 in)
EAS00292

CHECKING THE PRIMARY DRIVEN GEAR

1. Check:
• primary driven gear 1
Damage/wear → Replace the clutch hous-
ing and crankshaft as a set.
Excessive noise
Replace the clutch housing and crankshaft
as a set.
5 - 50
ENG
→
during operation