Measuring The Middle Gear Backlash - Yamaha FJR1300R Service Manual

MIDDLE GEAR
3. Tighten:
• middle driven shaft bearing housing bolts
NOTE:
@
Before tightening the bolts:
1. Adjust the middle gear backlash.
Refer to "ADJUSTING THE MIDDLE GEAR
BACKLASH".
2. Check that the middle driven gear turns
smoothly.
EAS00449
MEASURING THE MIDDLE GEAR
BACKLASH
1. Measure:
• middle gear backlash
Out of specification → Refer to "ADJUST-
ING THE MIDDLE GEAR BACKLASH".
Middle gear backlash
0.10 ~ 0.20 mm (0.004 ~ 0.008 in)
M MMM M MMM M M MMM M
a. Install the gear lash measurement tool 1
as shown.
Gear lash measurement tool
YM-01467
b. Make sure the dial gauge plunger contacts
the measuring point a on the middle gear
backlash band as shown.
a: 38 mm (1.50 in)
c. Hold the middle drive shaft 2.
5 - 74
ENG
25 Nm (2.5 m · kg, 18 ft · lb)
M MMM M M MMM M M MMM M MMM