Appendix 1 For Customers Who Are Replacing The Conventional Model With This Inverter; Appendix 1-1 Replacement Of The Fr-F500 Series - Mitsubishi Electric FR-F740-00023 Instruction Manual

For customers who are replacing the conventional model with this inverter
Appendix 1 For customers who are replacing the conventional model
with this inverter

Appendix 1-1 Replacement of the FR-F500 series

(1) Instructions for installation
1)Removal procedure of the front cover was changed. (with screws) Please note. (Refer to page 5.)
2)Removal procedure of the operation panel was changed. (with screws) Please note. (Refer to page 5.)
3)Plug-in options of the F500 series are not compatible
4)Operation panel (FR-DU04) can not be used.
5)Setup software (FR-SW0-SETUP) can not be used.
(2) Wiring instructions
1)The control circuit terminal block can be used for the FR-F700 series without removing wiring.
Note that the wiring cover (00023 to 00470) is not compatible.
FR-F500 series
(Note that the relay output 2 (A2, B2, C2) specific for the FR-F700 series can not be used with the FR-F500 series
terminals.)
(3) Instructions for continuous use of the FR-PU04 (parameter unit)
1) For the FR-F700 series, many functions (parameters) have been added. When setting these parameters, the
parameter name and setting range are not displayed. Parameter list, change list, initial value list, initial value list
2 and parameter clear of the HELP function can not be used.
2) For the FR-F700 series, many protective functions have been added. These functions activate, but all faults are
displayed as "Fault 14". When the faults history has been checked, "E.14" appears. Added faults display will not
appear on the parameter unit.
3) User initial value setting can not be used.
4) User registration/clear (user group 2) can not be used.
5) Parameter copy/verification function can not be used.
320
FR-F700 series