Lexmark W820 Service Manual page 250

Removal
1.
2.
3.
4.
5.
6.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
4-42
Service Manual
Remove the MP Feeder Assembly.
Remove the two screws securing the MP Feeder Top Cover to the MP Feeder
Assembly, and remove the Top Cover.
Disconnect the P/J that runs from the Tray Assembly to the Feeder Assembly.
Remove the screw securing the Tray Spring and free the Spring.
Push out on the Front Support as you slightly bow the Tray, and release the pivot
hole on the right side of the Tray from the metal shaft on the Front Support.
Remove the MP Feeder Tray Assembly.
Slide the pivot hole on the left side of the Tray onto the metal shaft on the Rear
Support.
Push out on the Front Support as you slightly bow the Tray, and slid the pivot hole on
the right side of the Tray into the metal shaft on the Front Support.
Reinstall the Tray Spring and use one screw to secure the Spring to the MP Feeder.
Insert the free end of the Tray Spring into the slot at the bottom edge of the Tray.
Reconnect the P/J that runs from the Tray Assembly to the Feeder Assembly.
Reinstall the MP Feeder Top Cover and use two screws to secure it to the MP
Feeder Assembly.
Reinstall the MP Feeder Assembly.
Reinstall the Duplex Unit if one was installed.
4025-XXX