Lexmark W820 Service Manual page 181

Top-level Menu
BASE SENSOR TEST
DEVICE TESTS
Only displayed if a flash or disk unit is installed.
PRINTER SETUP
4025-XXX
Intermediate Menu,
Printer Setting, or
Operation
Sensor Test
For additional
information, go to "Base
Sensor Test" on
page 3-21
Quick Disk Test
Only displayed when a
disk is installed.
Disk Test/Clean
Only displayed when a
disk is installed.
Flash Test
Only displayed when an
optional flash memory is
installed which is not
defective.
Defaults
Page Count
Perm Page Count
Serial Number
Configuration ID
Edge to Edge
Par S Strobe Adj
Only displayed if the
printer is configured with a
standard parallel port.
Par 1 Strobe Adj
Only displayed if a parallel
port is available using PCI
slot 1.
Par 2 Strobe Adj
Only displayed if a parallel
port is available using PCI
slot 2.
Value List
For additional information, go to
"Finisher Sensor Test" on
page 3-19.
Go to "Quick Disk Test" on
page 3-22.
Go to "Disk Test/Clean" on
page 3-22.
Go to "Flash Test" on
page 3-23.
U.S.*
Non-U.S.
0 to 9999999 (0)
0 to 9999999 (0)
xxxxxxxx (printer serial number)
where x = A - Z, 0 - 9, '-' or ''
000000 to 999999
Off*
On
-4 to 6 (0)
-4 to 6 (0)
-4 to 6 (0)
Diagnostic Aids
3-5