Lexmark W820 Service Manual page 229

Replacement
1.
Reinstall Tray 1 Take Away Roll Assembly onto the bottom of the printer frame.
2.
Align the two plastic mounting pins, located on the top of the Assembly, with the two
mounting holes located in the bottom of the printer frame.
3.
Press the Assembly into the frame so the mounting pins snap into the holes.
4.
Use two screws to secure the front of the Assembly to the printer frame.
5.
Use four screws to secure the rear of the Assembly to the printer frame.
6.
Reinstall Tray 1 Feed Clutch, along with the Gear and Bearing.
7.
Reinstall the Support Assembly Spring.
CAUTION: The printer is heavy and requires two people to lift it. Do not attempt to lift the
printer by yourself.
8.
Set the printer onto Tray 2.
9.
Reinstall Tray 1 Lift Motor.
10.
Reinstall the retaining clip that is located under the Option Connector Bracket, and
use one screw to secure the clip (Figure 1).
11.
Reinstall the Option Connector Bracket to the frame, and use one screw to secure
the Bracket.
12.
Reconnect J463, J464, J466, and J467 to the I/O PWB.
13.
Reinstall the docking clip to Tray 2, and use one screw to secure the clip.
14.
Reinstall the docking stud located at the lower right of the Tray, and use a retaining
clip to secure the stud.
15.
Reinstall the MP Feeder Support Assembly.
16.
Reinstall the Rear Cover Assembly.
17.
Reinstall the Left Upper Cover Assembly.
18.
Reinstall Tray 1 and Tray 2.
19.
Reinstall the EP Cartridge.
20.
Reinstall the Duplex Unit, if one was installed.
4025-XXX
4-21
Repair Information