Refitting The Gear Selector Lever - Ducati Diavel Workshop Manual

Hide thumbs Also See for Diavel:

Table of Contents

Gearbox assembly: gearchange mechanism

Refitting the gear selector lever

Position the gearbox drum selector fork in the centre of the gear rollers.

Position the gear selector lever (21) together with control shaft, spring and plate into the chain-side crankcase half.

Insert the screws (18) and (20) with the spacer (19).

Temporarily fit gear change lever (or a service lever) and engine pinion and shift to neutral gear.

Place the tool 88713.3334 on the gear claw.

Place the tool 88713.3334 inserting the clutch rod (E) into the tool hole, block the pin (F) of the tool in the gear claw

pressing with the hand in the point (G) (claw stroke lock plate) towards the right, as shown in photo.

Tighten the screw (18) in this position to a torque of 36 Nm (Min. 34 Nm - Max. 38 Nm) and screw (20) to a torque of 16

Nm (Min. 15 Nm - Max. 17 Nm) (Sect. 3 - 3,

Engine torque

Make sure that the gear selector lever fixing screws (18) and (20) are those indicated in our spare parts catalogue. They

Table of Contents

Diavel carbon